Subaru Legacy 2003 Service Manual page 2576

4) Install release lever seal.
( A )
( B )
(A) Release lever
(B) Release lever seal
5) Install transmission assembly.
<Ref. to MT-35, INSTALLATION, Manual Trans-
mission Assembly.>
2. TURBO MODEL
1) Install the release bearing on transmission.
2) Insert the release fork into release bearing tab.
( B )
(A) Release fork
(B) Release bearing
RELEASE BEARING AND LEVER
CL-00023
( A )
CL-00028
CL-23
3) Apply grease to the specified points:
• Spline FX2200 (Part No. 000040901)
• Shaft SUNLIGHT 2 (Part No. 003602010)
(A) Spline (FX2200)
(B) Shaft (SUNLIGHT 2)
4) Insert the release fork shaft into release fork.
NOTE:
Make sure the cutout portion of release fork shaft
contacts spring pin.
( C )
(A) Release fork
(B) Release shaft
(C) Spring pin
CLUTCH SYSTEM
( A )
( B )
CL-00029
( A )
( B )
CL-00030