Subaru Legacy 2003 Service Manual page 2229

AUTOMATIC TRANSMISSION
4) Attach the new O-ring to the oil seal retainer with
vaseline. Install the seal to the oil pump housing
bore.
( A )
(A) O-ring
5) Install the oil seal retainer taking care not to
damage the oil seal lips. Then secure with three
bolts.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
(A) Oil seal retainer
(B) Drive pinion shaft
6) Make sure the O-ring is fitted correctly in posi-
tion.
7) Secure the housing with two nuts and the bolt.
Tightening torque:
42 N·m (4.3 kgf-m, 31 ft-lb)
(A) Oil pump housing
OIL PUMP
AT-00186
( B )
( A )
AT-00187
( A )
AT-00188
AT-114
8) Install the torque converter clutch case assem-
bly to the transmission case assembly. <Ref. to AT-
85, INSTALLATION, Torque Converter Clutch As-
sembly.>
9) Install reduction driven gear. <Ref. to AT-102,
INSTALLATION, Reduction Driven Gear.>
10) Install the reduction drive gear. (MPT model)
<Ref. to AT-104, INSTALLATION, Reduction Drive
Gear.>
11) Install the center differential carrier. (VTD mod-
el) <Ref. to AT-106, INSTALLATION, Center Differ-
ential Carrier.>
12) Combine the extension case with the transmis-
sion case, and install vehicle speed sensor 1 (rear).
<Ref. to AT-86, INSTALLATION, Extension Case.>
13) Insert inhibitor switch and transmission con-
nector into stay.
( B )
(A) Transmission harness
(B) Inhibitor switch harness
14) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
15) Install the oil cooler pipe. <Ref. to AT-80, IN-
STALLATION, ATF Cooler Pipe and Hose.>
16) Install the oil charger pipe with O-ring. <Ref. to
AT-84, INSTALLATION, Oil Charger Pipe.>
17) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
18) Install the torque converter clutch assembly.
<Ref. to AT-85, INSTALLATION, Torque Converter
Clutch Assembly.>
( A )
AT-00174
AT-00291