CONTROL SYSTEMS
5) Tighten nut where cable end bolt comes to a
stop.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
6) Install in the reverse order of removal.
C: DISASSEMBLY
1) Remove spring.
( A )
(A) Spring
2) Remove lever, cap and bushing.
( D )
( E )
(A) Washer
(B) Bushing
(A) Plate ASSY
(D) Cushion
(E) Lever ASSY
MT DRIVE SELECT LEVER
CS-00070
( A )
( B )
( C )
CS-00071
D: ASSEMBLY
1) Assemble in the reverse order of disassembly.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
2) Make sure the select lever moves smoothly.
E: INSPECTION
1) Make sure the select lever moves smoothly. If it
does not move smoothly, repair or replace it.
2) Make sure the drive select lever is not damaged.
If it is damaged, repair or replace it.
CS-22