Subaru Legacy 2003 Service Manual page 2626

C: CAUTION
• Wear working clothing, including a cap, protective goggles, and protective shoes during operation.
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust or dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly, and replacement.
• Use SUBARU genuine grease etc. or the equivalent. Do not mix grease etc. with that of another grade or
from other manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or safety stands at the specified points.
• Apply grease onto sliding or revolution surfaces before installation.
• Before installing O-rings or snap rings, apply sufficient amount of grease to avoid damage and deforma-
tion.
• Before securing a part on a vise, place cushioning material such as wood blocks, aluminum plate, or shop
cloth between the part and the vise.
• Before disposing shock absorbers, be sure to bleed gas completely. Also, do not throw away in fire.
D: PREPARATION TOOL
1. SPECIAL TOOLS
ILLUSTRATION
( 1 )
( 2 )
ST-927380002
ST20099AE000
GENERAL DESCRIPTION
TOOL NUMBER DESCRIPTION
927380002 ADAPTER
20099AE000 INSTALLER &
REMOVER
RS-5
REMARKS
Used as an adapter for camber & caster gauge
when measuring camber and caster.
(1) 28199AC000 PLATE
(2) 28199AC010 BOLT
Used for replacing link rear bushing.
REAR SUSPENSION