Subaru Legacy 2003 Service Manual page 2246

B: INSTALLATION
1) Apply vaseline to thrust needle bearing.
2) Install the high clutch hub and thrust needle
bearing.
Attach the thrust needle bearing to the hub with va-
seline and install the hub by correctly engaging the
splines of the front planetary carrier.
( B )
(A) High clutch hub
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
3) Install the high clutch assembly.
(A)
(A) High clutch and reverse clutch assembly
4) Adjust total end play. <Ref. to AT-117, ADJUST-
MENT, Oil Pump.>
HIGH CLUTCH AND REVERSE CLUTCH
( C )
( E )
( D )
( A )
AT-00234
AT-00235
5) Install the thrust needle bearing in proper direc-
tion.
( A )
(A) High clutch and reverse clutch ASSY
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
6) Install the oil pump housing assembly.
7) Install the torque converter clutch case assem-
bly to the transmission case assembly. <Ref. to AT-
110, INSTALLATION, Torque Converter Clutch
Case.>
8) Insert inhibitor switch and transmission connec-
tor into stay.
9) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
(A) Transmission harness
(B) Inhibitor switch harness
10) Install oil cooler pipes. <Ref. to AT-80, INSTAL-
LATION, ATF Cooler Pipe and Hose.>
11) Install the oil charger pipe with O-ring. <Ref. to
AT-84, INSTALLATION, Oil Charger Pipe.>
AT-131
AUTOMATIC TRANSMISSION
( C )
( B )
( D )
AT-00312
( A )
( B )
AT-00174
( E )