Subaru Legacy 2003 Service Manual page 2525

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Remove snap ring.
(A) Snap ring
7) Remove inner snap ring.
8) Using a press and ST, remove ball bearing.
ST 498077000 RETAINER
ST
9) Remove oil seal from input shaft holder.
D: ASSEMBLY
1) Install ball bearing onto input shaft.
NOTE:
Place snap ring between input shaft gear and ball
bearing beforehand. Use the table at 8) as a guide
in selecting a suitable snap ring.
ST1 899580100 INSTALLER
ST2 399513600 INSTALLER
INPUT SHAFT ASSEMBLY
( A )
MT-00230
MT-00231
ST1
ST2
MT-00232
MT-84
2) Install snap ring on input shaft.
(A) Snap ring
3) Inspect clearance between ball bearing and
snap ring. <Ref. to MT-85, INSPECTION, Input
Shaft Assembly.>
4) Install straight pin and oil squeeze plate to input
shaft.
(A) Straight pin
(B) Oil squeeze plate
5) Install snap ring.
6) Drive oil seal into input shaft holder.
NOTE:
Apply a coat of grease to sealing lips before install-
ing oil seal.
ST 398507703 DUMMY COLLAR
( A )
MT-00230
( A )
( B )
MT-00234
ST
MT-00235