Subaru Legacy 2003 Service Manual page 2259

Hide thumbs Also See for Legacy 2003:

Table of Contents

AUTOMATIC TRANSMISSION

E: INSPECTION

1) Inspect the following items.

• Drive plate facing for wear and damage

• Snap ring for wear, return spring for breakage or

setting, and spring retainer for deformation

• Lip seal and D-ring for damage

• Piston check ball for operation

• Measure the total end play and adjust to within

specifications.

<Ref. to AT-117, ADJUSTMENT, Oil Pump.>

2) Place the same thickness of shim on both sides

to prevent retaining plate from tilting.

3) Inspect clearance between retaining plate and

operation of the low clutch.

Standard value:

0.7 — 1.1 mm (0.028 — 0.043 in)

Allowable limit:

1.6 mm (0.063 in)

(A) Thickness gauge

(B) Low clutch drum

4) If the clearance is out of the specified range, se-

lect a proper retaining plate so that the standard

clearance can be obtained.

Available retaining plates

PLANETARY GEAR AND LOW CLUTCH

Thickness mm (in)

Chapters

Table of Contents