Subaru Legacy 2003 Service Manual page 2510

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using ST1 and ST2, install the 5th gear thrust
washer and 5th needle bearing race onto the rear
section of transmission main shaft.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Face thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
7) Install bearing onto synchro cone.
8) Install baulk ring and synchro cone onto 5th-Rev
sleeve and hub assembly using ST and a press.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Use new ball bearing.
• After press fitting, make sure synchro cone ro-
tates freely.
ST 499757002
ST2
ST1
MT-00194
9) Install synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
( A )
MT-00195
MT-69
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
( A ) ( B )
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
(A) Synchro cone stopper
(B) Snap ring
ST
( C )
MT-00196
( B )
( A )
MT-00188