Subaru Legacy 2003 Service Manual page 2172

7) Install a new aluminum washer and oil cooler
pipes.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
T2: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T1
8) Install the transmission rear crossmember bolts.
Tightening torque:
70 N·m (7.1 kgf-m, 51 ft-lb)
9) Install the propeller shaft. <Ref. to DS-15, IN-
STALLATION, Propeller Shaft.>
10) Install the shield cover. (If equipped)
11) Install the front, center, rear exhaust pipes and
muffler. (Non-TURBO model)
With OBD
<Ref. to EX(H4SO)-6, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(H4SO)-9, INSTALLA-
TION, Rear Exhaust Pipe.> and <Ref. to
EX(H4SO)-10, INSTALLATION, Muffler.>
Without OBD
<Ref. to EX(H4SOw/oOBD)‑10, INSTALLATION,
Front Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)‑
13, INSTALLATION, Rear Exhaust Pipe.> and
<Ref. to EX(H4SOw/oOBD)‑14, INSTALLATION,
Muffler.>
3.0 L model
<Ref. to EX(H6DO)-6, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(H6DO)-8, INSTALLA-
TION, Rear Exhaust Pipe.> and <Ref. to
EX(H6DO)-9, INSTALLATION, Muffler.>
12) Install center and rear exhaust pipes, and muf-
fler. (TURBO model)
<Ref. to EX(H4DOSTC)-8, INSTALLATION, Cen-
ter Exhaust Pipe.>, <Ref. to EX(H4DOSTC)-12, IN-
STALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOSTC)-13, INSTALLATION, Muffler.>
13) Lower the vehicle.
14) Install the transmission connector to the stay.
15) Install the pitching stopper. <Ref. to AT-47, IN-
STALLATION, Transmission Mounting System.>
16) Install the air cleaner case. (2.0 L non-TURBO
and 2.5 L models)
<Ref. to IN(H4SO)-6, INSTALLATION, Air Cleaner
Case.>
FRONT VEHICLE SPEED SENSOR
T1
T2
AT-00805
AT-57
17) Install air intake chamber. (3.0 L model)
<Ref. to IN(H6DO)-6, INSTALLATION, Air Intake
Chamber.>
18) Install intercooler. (TURBO model)
<Ref. to IN(H4DOSTC)-14, INSTALLATION, Inter-
cooler.>
19) Fill ATF and check ATF level.
<Ref. to AT-30, Automatic Transmission Fluid.>
AUTOMATIC TRANSMISSION