Subaru Legacy 2003 Service Manual page 2586

10.Clutch Pedal
A: REMOVAL
1. LHD MODEL
1) Remove steering column. <Ref. to PS-28, RE-
MOVAL, Tilt Steering Column.>
2) Disconnect connectors from stop light and clutch
switches.
3) Remove snap pins which secure lever to push
rod and operating rod.
4) Remove clevis pins which secure lever to push
rod and operating rod.
( A )
( D )
( C )
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
5) Remove PHV adjusting nut and lock nut.
( C )
(A) Adjusting nut
(B) Lock nut
(C) PHV
CLUTCH PEDAL
( D )
( C )
( B )
CL-00090
( A )
( B )
CL-00091
6) Remove cable clamp, and disconnect PHV ca-
ble from PHV.
NOTE:
Carefully protect boot and inner cable from damage
when disconnecting PHV cable.
( A )
(A) PHV cable
(B) Clamp
7) Remove nut which secures clutch master cylin-
der.
8) Remove bolts and nuts which secure brake and
clutch pedals, and remove pedal assembly.
2. RHD MODEL
1) Disconnect ground cable from battery.
2) Remove lower cover under the stering wheel.
3) Disconnect connector from clutch. (With cruise
control)
4) Remove snap pin and clevis pin that join push
rod and clutch pedal.
CL-33
CLUTCH SYSTEM
( B )
CL-00092
CL-00093