Subaru Legacy 2003 Service Manual page 2201

AUTOMATIC TRANSMISSION
25.Extension Case
A: REMOVAL
1) Remove the transmission assembly. <Ref. to
AT-39, REMOVAL, Automatic Transmission As-
sembly.>
2) Remove rear vehicle speed sensor.
• MPT model
( B )
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
• VTD model
(A) Rear vehicle speed sensor
3) Separate transmission case and extension case
sections.
EXTENSION CASE
( A )
AT-00116
( A )
AT-00710
AT-00118
AT-86
B: INSTALLATION
1) Attach the selected thrust needle bearing to the
end surface of reduction drive gear with vaseline.
NOTE:
Install thrust needle bearing in the correct direction.
2) Install new gasket.
3) Install the extension case to the transmission
case.
4) Tighten bolts to secure the case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
5) Install the rear vehicle speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
• MPT model
( B )
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
AT-00118
( A )
AT-00116