Subaru Legacy 2003 Service Manual page 2503

Hide thumbs Also See for Legacy 2003:
Table of Contents

Advertisement

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Tighten 17 bolts with bracket, clip, etc. as shown
in the figure.
NOTE:
• Insert bolts from the bottom and tighten nuts at
the top.
• Put cases together so that drive pinion shim and
input shaft holder shim are not caught up in be-
tween.
• Confirm that speedometer gear is meshed.
Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.1 ft-lb)
10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
( 9 )
(13)
( 1 )
( 2 )
(15)
(14)
(10)
7) Tighten ball bearing attachment bolts.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
TRANSMISSION CASE
(16)
(17)
( 7 )
( 5 )
(11)
( 3 )
( 4 )
( 6 )
( 8 )
(12)
MT-00178
MT-00158
8) Backlash adjustment of hypoid gear and preload
adjustment of roller bearing
NOTE:
Support drive pinion assembly with ST.
ST 498427100
ST
9) Place the transmission with case left side facing
downward and put ST1 on bearing outer race.
10) Screw retainer assembly into left case from the
bottom with ST2. Fit ST3 on the transmission main
shaft. Shift gear into 4th or 5th and turn the shaft
several times. Screw in the retainer while turning
ST3 until a slight resistance is felt on ST2.
This is the contact point of hypoid gear and drive
pinion shaft. Repeat the above sequence several
times to ensure the contact point.
ST1 399780104
ST2 499787000
ST3 499927100
ST1
ST2
MT-62
STOPPER
MT-00174
WEIGHT
WRENCH ASSY
HANDLE
ST3
MT-00175

Advertisement

Table of Contents
loading

Table of Contents