Subaru Legacy 2003 Service Manual page 2157

AUTOMATIC TRANSMISSION
29) Place transmission jack under transmission.
NOTE:
Make sure that the support plates of transmission
jack don't touch the oil pan.
30) Remove transmission rear crossmember from
vehicle.
31) Remove transmission.
CAUTION:
Move transmission and torque converter as a
unit away from engine.
32) Separate transmission assembly and rear
cushion rubber.
AUTOMATIC TRANSMISSION ASSEMBLY
AT-00687
AT-00109
B: INSTALLATION
1) Install rear cushion rubber to transmission as-
sembly.
Tightening torque:
39 N·m (4.0 kgf-m, 29 ft-lb)
2) Install ST to torque converter clutch case.
ST 498277200
3) Install transmission onto engine.
(1) Gradually raise transmission with transmis-
sion jack.
(2) Engage them at splines.
4) Install transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2
5) Take off transmission jack.
AT-42
STOPPER SET
ST
AT-00103
AT-00109
T1
T2
AT-00688