Subaru Legacy 2003 Service Manual page 2182

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
17.Shift Solenoids, Duty Sole-
noids and ATF Temperature
Sensor
A: REMOVAL
1. SHIFT SOLENOIDS AND DUTY SOLE-
NOIDS
1) Lift-up the vehicle.
2) Clean the transmission exterior.
3) Replace the gasket with a new one, and tighten
the drain plug.
4) Drain the ATF completely.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
5) Remove the oil pan.
6) Disconnect the solenoid and duty solenoid con-
nectors.
( C )
( A )
( G )
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) Sport shift solenoid (Beige) (if equipped)
( B )
( A )
AT-00080
( B )
( D )
( E )
( J )
( I )
( H )
( F )
AT-00902
7) Remove the solenoids and duty solenoids.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) Sport shift solenoid (Beige) (if equipped)
2. ATF TEMPERATURE SENSOR
For removal of ATF temperature sensor, refer to
"Front Vehicle Speed Sensor." <Ref. to AT-54, RE-
MOVAL, Front Vehicle Speed Sensor.>
AT-67
AUTOMATIC TRANSMISSION
( C )
( A )
( B )
( G )
( D )
( E )
( H )
( F )
AT-00903