Subaru Legacy 2003 Service Manual page 2106

6) Connect stay to transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
( A )
(A) Stay
(B) Transmission bracket
7) Install heat shield cover. (If equipped)
8) Install rear exhaust pipe and muffler.
2.0 L (non-turbo) and 2.5 L with OBD models
<Ref. to EX(H4SO)-9, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H4SO)-10, INSTAL-
LATION, Muffler.>
2.0 L (non-turbo) and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-13, INSTALLATION,
Rear Exhaust Pipe.> and <Ref. to EX(H4SOw/
oOBD)-14, INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-8, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H6DO)-9, INSTAL-
LATION, Muffler.>
Turbo model
<Ref. to EX(H4DOSTC)-12, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4DOSTC)-13,
INSTALLATION, Muffler.>
MT GEAR SHIFT LEVER
( B )
CS-00050
AT-00682
9) Install the plate assembly to body.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
10) Install the drive select cable. (Dual-range mod-
el)
<Ref. to CS-23, INSTALLATION, Drive Select Ca-
ble.>
11) Install the boot and insulator assembly to vehi-
cle in proper direction.
12) Install the clamp.
13) Install console box. <Ref. to EI-34, INSTALLA-
TION, Console Box.>
CS-17
CONTROL SYSTEMS
CS-00157
CS-00156