Subaru Legacy 2003 Service Manual page 2103

CONTROL SYSTEMS
D: ADJUSTMENT
1) Prior to removal, set lever to "N" position.
2) Remove rear exhaust pipe and muffler.
2.0 L (non-turbo) and 2.5 L with OBD models
<Ref. to EX(H4SO)-9, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SO)-10, REMOVAL,
Muffler.>
2.0 L (non-turbo) and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-13, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SOw/oOBD)-
14, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-8, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H6DO)-9, REMOVAL, Muf-
fler.>
Turbo model
<Ref. to EX(H4DOSTC)-12, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(H4DOSTC)-13, RE-
MOVAL, Muffler.>
3) Remove heat shield cover. (If equipped)
4) Loosen the adjusting nut on each side.
(A) Adjusting nut A
(B) Adjusting nut B
SELECT CABLE
AT-00682
( B ) ( A )
CS-00040
CS-14
5) Turn adjusting nut B until it lightly touches the
connector.
( A )
( D )
(A) Front side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
6) While preventing adjusting nut B from moving
with a wrench, tighten adjusting nut A.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
( B )
(A) Adjusting nut A
(B) Adjusting nut B
7) After completion of fitting, make sure that the se-
lect lever operates smoothly all across the operat-
ing range.
8) Install in the reverse order of removal.
( B )
( C )
( F )
( E )
CS-00041
( A )
CS-00042