Subaru Legacy 2003 Service Manual page 2477

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Tighten nuts which hold lower side of transmis-
sion to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
7) Connect engine and transmission.
(1) Install starter.
Non-TURBO model
<Ref. to SC(H4SO)-6, INSTALLATION, Start-
er.>
TURBO model
<Ref. to SC(H4DOSTC)-6, INSTALLATION,
Starter.>
(2) Tighten bolt which holds right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
8) Remove ST.
MANUAL TRANSMISSION ASSEMBLY
MT-00077
MT-00073
ST
MT-00070
9) Push the clutch release lever to fit bearing into
clutch cover.
10) Install pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
11) Lift up the vehicle.
12) Install front drive shafts into transmission.
13) New drive spring pin into chamfered hole of
drive shaft.
MT-36
T2 T1
MT-00383
MT-00358
MT-00357