Subaru Legacy 2003 Service Manual page 1867

ENGINE (DIAGNOSTICS)
Power steering switch signal
Rear oxygen sensor rich signal
Starter switch signal
Idle switch signal
Crankshaft position sensor signal
Camshaft position sensor signal
Rear defogger switch signal
Blower fan switch signal
Small light switch signal
Supercharged pressure relief valve solenoid 1 signal
Supercharged pressure relief valve solenoid 2 signal
Exhaust gas positive pressure signal
Exhaust gas negative pressure signal
Read memory connector signal
MT/AT identification signal
TCS relief valve solenoid signal
Engine torque control signal #1
Engine torque control signal #2
Engine torque control permission signal
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
5. READ CURRENT DATA FOR ENGINE. (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press [YES]
key.
3) Press the [YES] key after displayed the information of engine type.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press [YES] key.
5) On the «OBD Menu» display screen, select the {Current Data Display & Save} and press [YES] key.
6) On the «Data Display Menu» display screen, select the {Data Display} and press [YES] key.
7) Using the scroll key, move the display screen up or down until desired data is shown.
• A list of the support data is shown in the following table.
Number of diagnosis code
Malfunction indicator lamp status
Monitoring test of misfire
Monitoring test of fuel system
Monitoring test of comprehensive component
Test of catalyst
Test of heated catalyst
Test of evaporative emission purge control system
Test of secondary air system
Test of air conditioning system refrigerant
Test of oxygen sensor
Test of oxygen sensor heater
Test of EGR system
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR
Contents
Contents
EN(H4DOSTC)-28
Display
P/S Switch
Rear O2 Rich Signal
Starter Switch
Idle Switch Signal
Crankshaft Position Sig.
Camshaft Position Sig.
Rear Defogger SW
Blower Fan SW
Light Switch
Relief Valve Solenoid 1
Relief Valve Solenoid 2
Ex. Gas Pos. Pressure
Ex. Gas Neg. Pressure
Read Memory Signal
AT Vehicle ID Signal
TCS Relief Valve Sol.
Torque Control Signal #1
Torque Control Signal #2
Torque Permission Signal
Display
Number of Diagnosis Code
MI (MI)
Misfire monitoring
Fuel system monitoring
Component monitoring
Catalyst Diagnosis
Heated catalyst
Evaporative purge system
Secondary air system
A/C system refrigerant
Oxygen sensor
O2 Heater Diagnosis
EGR system
Unit of measure
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
Unit of measure
—
Complete or incomplete
No support
Complete or incomplete
Complete or incomplete
No support
No support
No support
No support
No support
Complete or incomplete
Complete or incomplete
No support