Manual Transmission Assembly - Subaru Legacy 2003 Service Manual

MANUAL TRANSMISSION AND DIFFERENTIAL
3. Manual Transmission As-
sembly
A: REMOVAL
1) Set vehicle on a lift.
2) Open front hood fully, and support with stay.
3) Disconnect battery ground cable.
4) Move shift lever to "N", and release the parking
brake.
5) Remove air intake duct and cleaner case. (NA
model) <Ref. to IN(H4SO)-6, REMOVAL, Air
Cleaner Case.> and <Ref. to IN(H4SO)-7, RE-
MOVAL, Air Intake Duct.>
6) Remove the intercooler. (TURBO model) <Ref.
to IN(H4DOSTC)-13, REMOVAL, Intercooler.>
7) Remove air cleaner case stay.
8) Disconnect the following connectors.
(1) Neutral position switch connector
(2) Back-up light switch connector
(3) High-low switch connector (Dual-range
model)
Non-TURBO model

MANUAL TRANSMISSION ASSEMBLY

MT-00062
MT-00063
TURBO model
(4) Vehicle speed sensor
9) Remove snap pin and pin from the drive select
cable.
10) Remove the drive select cable on the transmis-
sion. (Dual-range model)
( C )
(A) Snap pin
(B) Pin
(C) Drive select cable
11) Remove starter.
Non-TURBO model
<Ref. to SC(H4SO)-6, REMOVAL, Starter.>
TURBO model
<Ref. to SC(H4DOSTC)-6, REMOVAL, Starter.>
MT-32
MT-00382
MT-00065
( A )
( B )
MT-00066