Subaru Legacy 2003 Service Manual page 2620

Hide thumbs Also See for Legacy 2003:

Table of Contents

8. Front Support Arm

1) Set the vehicle on the lift.

2) Lift-up the vehicle.

3) Remove the under cover.

4) Remove the four bolts and jack-up plate.

5) Remove the two nuts at both ends of the arm re-

B: INSTALLATION

Install in the reverse order of removal.

Tightening torque:

Front support arm to crossmember:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

Jack-up plate to crossmember:

70 N·m (7.1 kgf-m, 51.6 ft-lb)

C: INSPECTION

Check the front support arm for wear, damage and

cracks, and correct or replace if defective.

FRONT SUPPORT ARM

FRONT SUSPENSION

Chapters

Table of Contents