AUTOMATIC TRANSMISSION
10) Remove ST.
11) Install pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
12) Lift-up the vehicle.
13) Install front drive shafts into transmission.
(1) Lift-up the vehicle.
(2) Install front drive shaft into transmission.
(3) New drive spring pin into chamfered hole of
drive shaft.
14) Install ball joint into housing.
AUTOMATIC TRANSMISSION ASSEMBLY
ST
AT-00105
T1
AT-00691
AT-00685
15) Connect stabilizer link to transverse link, and
tighten bolts. (Non-TURBO model)
NOTE:
Discard loosened self-locking nut and replace with
a new one.
Tightening torque:
T1: 30 N·m (3.1 kgf-m, 22.4 ft-lb)
T2: 50 N·m (5.1 kgf-m, 37 ft-lb)
16) Tighten the installing bolts. (TURBO model)
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
17) Install the stabilizer link to transverse link.
(TURBO model)
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
18) Install shift select cable onto select lever.
<Ref. to CS-13, INSTALLATION, Select Cable.>
AT-44
T2
T1
AT-00692
AT-00809
AT-00810