Subaru Legacy 2003 Service Manual page 2267

AUTOMATIC TRANSMISSION
8) Install 2-4 brake. <Ref. to AT-146, INSTALLA-
TION, 2-4 Brake.>
9) Install planetary gear and low clutch assembly to
transmission case.
Install carefully while rotating the low clutch and
planetary gear assembly slowly paying special at-
tention not to damage the seal ring. <Ref. to AT-
137, INSTALLATION, Planetary Gear and Low
Clutch.>
10) Install the high clutch assembly. <Ref. to AT-
131, INSTALLATION, High Clutch and Reverse
Clutch.>
11) Install the oil pump housing assembly. <Ref. to
AT-113, INSTALLATION, Oil Pump.>
12) Install control valve assembly and oil pan.
<Ref. to AT-61, INSTALLATION, Control Valve
Body.>
13) Install the torque converter clutch case assem-
bly. <Ref. to AT-110, INSTALLATION, Torque
Converter Clutch Case.>
14) Install reduction driven gear.
<Ref. to AT-102, INSTALLATION, Reduction Driv-
en Gear.>
15) Install reduction drive gear. (MPT model)
16) Install the center differential carrier. (VTD mod-
el) <Ref. to AT-106, INSTALLATION, Center Differ-
ential Carrier.>
17) Install the extension case to the transmission
case. <Ref. to AT-86, INSTALLATION, Extension
Case.>
18) Install the rear vehicle speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
19) Insert inhibitor switch and transmission con-
nector into stay.
( B )
(A) Transmission harness
(B) Inhibitor switch harness
20) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
21) Install the oil cooler pipes. <Ref. to AT-80, IN-
STALLATION, ATF Cooler Pipe and Hose.>
22) Install the oil charger pipe with O-ring. <Ref. to
AT-84, INSTALLATION, Oil Charger Pipe.>
ONE-WAY CLUTCH
23) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
24) Install the torque converter clutch assembly.
<Ref. to AT-85, INSTALLATION, Torque Converter
Clutch Assembly.>
25) Install the transmission assembly to the vehi-
cle. <Ref. to AT-42, INSTALLATION, Automatic
Transmission Assembly.>
( A )
AT-00174
AT-152
50 — 55 mm (1.97 — 2.17 in)
A
AT-00291