Subaru Legacy 2003 Service Manual page 2105

CONTROL SYSTEMS
14) Remove cushion rubber from body.
( A )
(A) Stay
(B) Cushion rubber
15) Remove joint and then extract spring pin.
( B )
(A) Joint
(B) Spring pin
16) Lower the vehicle.
17) Remove gear shift lever.
MT GEAR SHIFT LEVER
( B )
CS-00052
( A )
CS-00053
CS-00054
B: INSTALLATION
1) Install the joint to the transmission and secure
with the spring pin.
2) Insert gear shift lever from room side.
NOTE:
After inserting rod and stay, temporarily put them
onto transmission mount.
3) Lift-up the vehicle.
4) Mount cushion rubber on the body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
( A )
(A) Stay
(B) Cushion rubber
5) Connect rod to the joint.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(A) Stay
(B) Rod
CS-16
CS-00054
( B )
CS-00052
( A )
( B )
CS-00051