Subaru Legacy 2003 Service Manual page 2100

8) Remove the clip, and then remove the rod and
the spring.
( A )
(A) Clip
(B) Bushing
(C) Spring
(D) Rod
9) Remove the bolt.
10) Remove the bracket guide assembly.
11) Remove the grommet, and then extract spring
pin from the top.
SELECT LEVER
( D )
( C )
( B )
CS-00150
CS-00187
CS-00188
CS-00211
12) Remove the arm assembly and then take away
the lever and arm bracket from base plate.
( C )
(A) Arm ASSY
(B) Lever
(C) Base plate
(D) Arm bracket
13) Remove the spring, and then remove the de-
tent arm.
D: ASSEMBLY
1) Clean all parts before assembly.
2) Apply grease
003602010) or equivalent] to each parts. <Ref. to
CS-3, AT SELECT LEVER (EXCEPT SPORT
SHIFT MODEL), COMPONENT, General Descrip-
tion.> and <Ref. to CS-4, AT SELECT LEVER
(SPORT SHIFT MODEL), COMPONENT, General
Description.>
3) Assembly is in the reverse order of disassembly.
4) After completion of fitting, transfer the select le-
ver to range "P" — "1", then check whether the in-
dicator and select lever agree, whether the pointer
and position mark agree and what the operating
force is.
E: INSPECTION
1) Inspect the removed parts by comparing with
new ones for deformation, damage and wear. Cor-
rect or replace if defective.
2) Confirm the following parts for operating condi-
tion before assembly. Moving condition of the se-
lect lever assembly, it should move smoothly.
CS-11
CONTROL SYSTEMS
( A )
( B )
( A )
CS-00189
[SUNLIGHT 2 (Part No.