Subaru Legacy 2003 Service Manual page 2484

B: INSTALLATION
1. BACK-UP LIGHT SWITCH AND NEU-
TRAL POSITION SWITCH
1) Install back-up light switch and neutral position
switch with harness.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
( B )
(A) Neutral switch
(B) Back-up light switch
2) Connect connector of back-up light switch and
neutral position switch.
3) Install air intake duct and cleaner case. (Non-
TURBO model)
<Ref. to IN(H4SO)-6, INSTALLATION, Air Cleaner
Case.> and <Ref. to IN(H4SO)-7, INSTALLATION,
Air Intake Duct.>
4) Install the intercooler (TURBO model)
<Ref. to IN(H4DOSTC)-14, INSTALLATION, Inter-
cooler.>
5) Connect battery ground cable.
2. HIGH-LOW SWITCH
1) Install high-low switch.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
2) Install HI-LO switch cable to the clamp.
3) Connect connector high-low switch.
4) Install air intake duct and cleaner case.
<Ref. to IN(H4SO)-6, INSTALLATION, Air Cleaner
Case.> and <Ref. to IN(H4SO)-7, INSTALLATION,
Air Intake Duct.>
5) Connect battery ground cable.
SWITCHES AND HARNESS
( A )
MT-00106
MT-43
MANUAL TRANSMISSION AND DIFFERENTIAL
C: INSPECTION
1. BACK-UP LIGHT SWITCH
Inspect the back-up light switch. <Ref. to LI-7, IN-
SPECTION, Back-up Light System.>
2. NEUTRAL POSITION SWITCH
1) Turn ignition switch to OFF.
2) Disconnect connector neutral position switch.
3) Measure resistance between neutral position
switch terminals.
Non-TURBO model
Gear shift position Terminal No.
Neutral position
Other positions
TURBO model
Gear shift position Terminal No.
Neutral position
Other positions
4) Replace defective parts if outside the standard
value.
Specified resis-
tance
More than 1 MΩ
1 and 2
Less than 1 Ω
2 1
MT-00110
Specified resis-
tance
More than 1 MΩ
1 and 3
Less than 1 Ω
2 1
4 3
MT-00111