Subaru Legacy 2003 Service Manual page 1749

EXHAUST
14) Disconnect the connector from rear oxygen
sensor.
15) Vertically draw out the clip from crossmember.
16) Separate the center exhaust pipe from rear ex-
haust pipe.
17) Remove the bolt which holds center exhaust
pipe bracket to transmission.
CENTER EXHAUST PIPE
18) Remove the bolts which hold center exhaust
pipe to hanger bracket.
CAUTION:
Be careful not to pull down the center exhaust
pipe.
FU-00669
19) Remove the center exhaust pipe.
B: INSTALLATION
NOTE:
Replace the gaskets with new ones.
1) Install the center exhaust pipe and temporarily
tighten the bolt which holds center exhaust pipe to
hanger bracket.
2) Temporarily tighten the bolt which holds center
pipe to transmission.
EX-00085
3) Connect the center exhaust pipe (RH) to sec-
ondary turbocharger.
Tightening torque:
EX-00086
EX(H4DOSTC)-8
35 N·m (3.6 kgf-m, 26.0 ft-lb)
(A)
(A) Center exhaust pipe (RH)
(B) Secondary turbocharger
EX-00087
(B)
EX-00083