AUTOMATIC TRANSMISSION
3) Install new O-ring.
E: INSPECTION
• Check each component for harmful cuts, dam-
age and other faults.
• Measure the backlash and adjust to within spec-
ifications.
<Ref. to AT-128, ADJUSTMENT, Front Differen-
tial.>
FRONT DIFFERENTIAL
F: ADJUSTMENT
1) Using ST, screw in the retainer until light contact
is felt.
NOTE:
Screw in the RH side slightly deeper than the LH
side.
ST 499787000
AT-00219
2) Remove the oil pump housing.
3) Thoroughly remove the liquid gasket from the
case mating surface beforehand.
4) Install the oil pump housing assembly to the
torque converter clutch case, and secure evenly by
tightening four bolts.
NOTE:
Use an old gasket or an aluminum washer so as not
to damage the mating surface of the housing.
Tightening torque:
AT-128
WRENCH ASSY
41 N·m (4.2 kgf-m, 30.4 ft-lb)
ST
AT-00227
AT-00205