Subaru Legacy 2003 Service Manual page 1672

8. Valve Clearance
A: INSPECTION
Inspection and adjustment of the valve clearance
should be performed while engine is cold.
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the air
IN(H4DOSTC)-11, REMOVAL, Air Intake Duct.>
4) Remove the bolt which secures belt cover (RH).
5) Lift-up the vehicle.
6) Remove the under cover.
7) Loosen the remaining bolts which secure belt
cover (RH), and then remove the belt cover.
8) Lower the vehicle.
9) When inspecting the #1 and #3 cylinders:
(1) Pull out the engine harness connector with
bracket from air cleaner upper cover.
(2) Remove the air cleaner case. <Ref. to
IN(H4DOSTC)-10, REMOVAL, Air Cleaner.>
(3) Disconnect the ignition coil connector.
(4) Remove the ignition coil.
(5) Place a suitable container under the vehicle.
(6) Disconnect the PCV hose from rocker cover
(RH).
(7) Remove the bolts, and then remove the
rocker cover (RH).
10) When inspecting the #2 and #4 cylinders:
VALVE CLEARANCE
FU-00009
intake duct. <Ref.
ME-00012
ME(H4DOSTC)-27
(1) Disconnect the battery cable, and then re-
move the battery and battery carrier.
(2) Remove the bolt which secures engine har-
ness bracket onto body.
to
(3) Disconnect the washer motor connectors.
(4) Remove the washer tank mounting bolts.
MECHANICAL
ME-00013
ME-00014
ME-00015
ME-00016