Subaru Legacy 2003 Service Manual page 2566

Hide thumbs Also See for Legacy 2003:

Table of Contents

GENERAL DESCRIPTION

CLUTCH SYSTEM

• Wear working clothing, including a cap, protec-

tive goggles, and protective shoes during opera-

• Remove contamination including dirt and corro-

sion before removal, installation or disassembly.

• Keep the disassembled parts in order and pro-

tect them from dust or dirt.

• Before removal, installation or disassembly, be

sure to clarify the failure. Avoid unnecessary re-

moval, installation, disassembly, and replacement.

• Be careful not to burn your hands, because each

part on the vehicle is hot after running.

• Use SUBARU genuine fluid, grease etc. or the

equivalent. Do not mix fluid, grease etc. with that of

another grade or from other manufacturers.

• Be sure to tighten fasteners including bolts and

nuts to the specified torque.

• Place shop jacks or safety stands at the specified

• Apply grease onto sliding or revolution surfaces

before installation.

• Before installing O-rings or snap rings, apply suf-

ficient amount of fluid to avoid damage and defor-

• Before securing a part on a vise, place cushion-

ing material such as wood blocks, aluminum plate,

or shop cloth between the part and the vise.

• Keep fluid away from the vehicle body. If any flu-

id contacts the vehicle body, immediately flush the

area with water.

Chapters

Table of Contents