Subaru Legacy 2003 Service Manual page 2098

11) Install rear exhaust pipe and muffler.
2.0 L and 2.5 L with OBD models
<Ref. to EX(H4SO)-9, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H4SO)-10, INSTAL-
LATION, Muffler.>
2.0 L and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-13, INSTALLATION,
Rear Exhaust Pipe.> and <Ref. to EX(H4SOw/
oOBD)-14, INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-8, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H6DO)-9, INSTAL-
LATION, Muffler.>
Turbo model
<Ref. to EX(H4DOSTC)-12, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4DOSTC)-13,
INSTALLATION, Muffler.>
12) Inspect the following items. If the following in-
spection reveals problems, adjust the select cable
and inhibitor switch. <Ref. to CS-14, ADJUST-
MENT, Select Cable.> and <Ref. to AT-50, AD-
JUSTMENT, Inhibitor Switch.>
(1) The engine starts operating when select le-
ver is in position "P" and "N", but not in other po-
sitions.
(2) The back-up light is lit when the select lever
is in position "R", but not in other positions.
(3) Select lever and indicator positions are
matched.
SELECT LEVER
C: DISASSEMBLY
1. EXCEPT SPORT SHIFT MODEL
1) Remove grip.
2) Remove bulb and then remove indicator.
NOTE:
Be careful not to break the bulb during removal.
(A) Grip
(B) Indicator
(C) Bulb
3) Remove blind.
4) Remove clips and then remove guide plate.
(A) Clips
(B) Guide plate
5) Remove cap and then extract spring pin.
(A) Spring pin
(B) Arm ASSY
CS-9
CONTROL SYSTEMS
( A )
( B )
( C )
( B )
( A )
( B )
CS-00179
( A )
CS-00180
( A )
CS-00181