Subaru Legacy 2003 Service Manual page 2262

4) Position snap ring in transmission. Using ST,
press the snap ring into place.
ST 498677100 COMPRESSOR
ST
5) Install planetary gear and low clutch assembly to
transmission case.
Install carefully while rotating the low clutch and
planetary gear assembly slowly paying special at-
tention not to damage the seal ring. <Ref. to AT-
137, INSTALLATION, Planetary Gear and Low
Clutch.>
6) Install pressure plate, drive plate, driven plate,
retaining plate and snap ring.
7) Install a new 2-4 brake oil seal to transmission
case.
2-4 BRAKE
8) After all 2-4 brake component parts have been
installed, blow in air intermittently and confirm the
operation of the brake.
AT-00289
9) Check the clearance between the retaining plate
and the snap ring.<Ref. to AT-149, INSPECTION,
2-4 Brake.>
10) Be careful not to mistake the location of the leaf
spring to be inserted.
AT-00254
11) Install thrust needle bearing in the correct di-
rection.
AT-00284
12) Install front sun gear.
AT-147
AUTOMATIC TRANSMISSION
( A )
( B )
(A) Leaf spring
(B) Retaining plate
( A )
(A) Snap ring
(B) Thrust needle bearing
(C) Upside
(D) Downside
AT-00290
AT-00252
( C )
( E )
( D )
( B )
AT-00256