Subaru Legacy 2003 Service Manual page 2587

CLUTCH SYSTEM
5) Remove master cylinder mounting nuts.
( A )
(A) Master cylinder
6) Remove PHV adjusting nut and lock nut. (Non-
Turbo model)
( C )
(A) Adjusting nut
(B) Lock nut
(C) PHV
7) Remove cable clamp and disconnect PHV cable
from PHV.
NOTE:
Carefully protect boot and inner cable from damage
when disconnecting PHV cable.
( A )
( B )
(A) PHV cable
(B) Clamp
CLUTCH PEDAL
CL-00074
( A )
( B )
CL-00091
CL-00092
8) Remove clutch pedal and bracket as a unit.
(A) Clutch pedal bracket
(B) Clutch pedal
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
• If cable clamp is damaged, replace it with a new
one.
• Never fail to cover outer cable end with boot.
• Be careful not to kink accelerator cable.
• Always use new clevis pins.
2) Adjust clutch pedal. <Ref. to CL-37, ADJUST-
MENT, Clutch Pedal.>
3) Adjust hill holder. (Non-Turbo model) <Ref. to
BR-49, ADJUSTMENT, Hill Holder.>
C: DISASSEMBLY
1. LHD MODEL
1) Remove clutch switches.
2) Remove clips, assist spring, rod and bushing.
( A )
( C )
( D )
( B )
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
CL-34
( A )
( B )
( D )
( D )
( E )
( C )
CL-00126
CL-00094