Subaru Legacy 2003 Service Manual page 2171

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Pass the harness assembly through the hole in
the transmission case.
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
Tightening torque (Transmission ground cable
and ATF temperature sensor)
8 N·m (0.8 kgf-m, 5.8 ft-lb)
( B )
( C )
( A )
( J )
( G )
(A) Lock-up duty solenoid (Blue)
(B) Transmission ground
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Low clutch timing solenoid (Gray)
(K) Sport shift solenoid (Beige) (if equipped)
FRONT VEHICLE SPEED SENSOR
AT-00048
( D )
( E )
( K )
( I )
( H )
( F )
AT-00695
AT-56
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B (Part No.
K0877YA020)
4) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B (Part No.
K0877YA020)
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front and rear vehicle speed sensor,
and also the torque converter turbine speed sen-
sor, and then fasten the harness.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
AT-00051
AT-00052