Subaru Legacy 2003 Service Manual page 2511

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Install the rest parts to the rear section of trans-
mission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
( A ) ( B ) ( C )
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
11) Tighten lock nuts to the specified torque using
ST1 and ST2.
NOTE:
Secure lock nuts in two places after tightening.
ST1 499987003 SOCKET WRENCH
ST2 498937000 TRANSMISSION HOLDER
Tightening torque:
118 N·m (12.0 kgf-m, 86.8 ft-lb)
( D )
( E )
( F )
MT-00198
2. EXCEPT 2.0 L SOHC
1) Assemble each sleeve and hub assembly.
NOTE:
Position open ends of spring 120° apart.
( A )
( B )
( C )
( D )
(A) 3rd-4th hub ASSY
(B) 3rd gear side
(C) 5th-Rev hub ASSY
(D) 5th gear side
MT-70
MT-00191