Subaru Legacy 2003 Service Manual page 2104

4. MT Gear Shift Lever
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect negative cable from battery.
3) Remove gear shift knob.
4) Remove console box. <Ref. to EI-34, REMOV-
AL, Console Box.>
5) Remove the clamp.
6) Remove the boot and insulator assembly.
7) Remove the drive select cable. (Dual-range
model)
<Ref. to CS-23, REMOVAL, Drive Select Cable.>
8) Remove the plate assembly from body.
9) Lift-up the vehicle.
10) Remove rear exhaust pipe and muffler.
2.0 L (non-turbo) and 2.5 L with OBD models
<Ref. to EX(H4SO)-9, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SO)-10, REMOVAL,
Muffler.>
2.0 L (non-turbo) and 2.5 L without OBD models
MT GEAR SHIFT LEVER
<Ref. to EX(H4SOw/oOBD)-13, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SOw/oOBD)-
14, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-8, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H6DO)-9, REMOVAL, Muf-
fler.>
Turbo model
<Ref. to EX(H4DOSTC)-12, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(H4DOSTC)-13, RE-
MOVAL, Muffler.>
11) Remove heat shield cover. (If equipped)
CS-00155
12) Remove stay from transmission bracket.
CS-00156
13) Remove rod from joint.
CS-00157
CS-15
( A )
( B )
(A) Stay
(B) Transmission bracket
( A )
(A) Stay
(B) Rod
CONTROL SYSTEMS
AT-00682
CS-00050
( B )
CS-00051