Subaru Legacy 2003 Service Manual page 2569

CLUTCH SYSTEM
2) Install clutch cover on flywheel and tighten bolts
to the specified torque.
NOTE:
• Align matching marks.
• Note the front and rear of the clutch disc when in-
stalling.
• Tighten clutch cover installing bolts gradually.
Each bolt should be tightened to the specified
torque in a crisscross fashion.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
( 3 )
( 5 )
( 2 )
3) Remove ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install transmission assembly. <Ref. to MT-35,
INSTALLATION, Manual Transmission Assem-
bly.>
2. EXCEPT EUROPE AND AUSTRALIA
NON-TURBO MODELS AND TURBO MOD-
EL
1) Insert ST into the clutch disc and install them on
the flywheel by inserting the ST end into the pilot
bearing.
NOTE:
When installing clutch disc, be careful its direction.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
CLUTCH DISC AND COVER
( 1 )
( 6 )
( 4 )
CL-00115
ST
(A)
CL-00012
CL-16
2) Install clutch cover on flywheel and tighten bolts
to the specified torque.
NOTE:
• When installing the clutch cover on the flywheel,
position the clutch cover so that there is a gap of
120° or more between "0" marks on the flywheel
and clutch cover. ("0" marks indicate the directions
of residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
• Temporarily tighten bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross fashion.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
( 3 )
( 5 )
( 2 )
(A) "0" marks
3) Remove ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install transmission assembly. <Ref. to MT-35,
INSTALLATION, Manual Transmission Assem-
bly.>
( A )
( 1 )
( 6 )
( 4 )
ST
CL-00013