Subaru Legacy 2003 Service Manual page 2193

AUTOMATIC TRANSMISSION
21.ATF Cooler Pipe and Hose
A: REMOVAL
1. EXCEPT 3.0 L MODEL
1) Set the vehicle on a lift.
2) Remove battery and washer tank.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect ATF cooler hose from radiator.
NOTE:
• Do not remove with a screwdriver or other point-
ed tools.
• When the hose is difficult to remove, wrap a shop
cloth around the hose to protect it. Turn it with pli-
ers, and then pull directly out with your hand.
6) Disconnect ATF cooler hoses from pipes.
NOTE:
• Do not remove with a screwdriver or other point-
ed tools.
• When the hose is difficult to remove, wrap a shop
cloth around the hose to protect it. Turn it with pli-
ers, and then pull directly out with your hand.
ATF COOLER PIPE AND HOSE
AT-00703
AT-00683
AT-78
7) Remove ATF cooler pipe from frame.
8) Remove the oil cooler inlet and outlet pipes.
NOTE:
When removing outlet pipe, be careful not to lose
ball and spring used with retaining screw.
( B )
(A) Inlet pipe
(B) Outlet pipe
AT-00704
( A )
AT-00806