Subaru Legacy 2003 Service Manual page 1682

6) Remove the garage jack.
7) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
8) Remove the ST from torque converter clutch
case. (AT vehicles)
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing ST.
ST 498277200 STOPPER SET
9) Install the starter. <Ref. to SC(H4DOSTC)-6, IN-
STALLATION, Starter.>
10) Install the torque converter clutch onto drive
plate. (AT vehicles)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
NOTE:
Be careful not to drop bolts into the torque convert-
er clutch housing.
ST 499977300 CRANK PULLEY WRENCH
ENGINE ASSEMBLY
Tightening torque:
ME-00047
(3) Clog the service hole with plug.
11) Install the fuel filter and bracket.
T1
12) Install the power steering pump on bracket.
MT-00085
(1) Install the power steering tank on bracket.
(2) Install the power steering pump.
Tightening torque:
ME(H4DOSTC)-37
25 N·m (2.5 kgf-m, 18.1 ft-lb)
20.1 N·m (2.05 kgf-m, 14.8 ft-lb)
MECHANICAL
ME-00044
ME-00046
ME-00038
ME-00037