Subaru Legacy 2003 Service Manual page 1695

MECHANICAL
(1) Align mark (A) on the crankshaft sprocket
with mark on the oil pump cover at cylinder
block.
(A)
(2) Align single line mark (A) on the exhaust
camshaft sprocket (RH) with notch (B) on belt
cover.
( A )
( B )
(3) Align single line mark (A) on the intake cam-
shaft sprocket (RH) with notch (B) on belt cover.
(Make sure double lines (C) on intake camshaft
and exhaust camshaft sprockets are aligned.)
( B )
( A )
( C )
TIMING BELT ASSEMBLY
ME-00081
ME-00082
CAUTION:
• Intake and exhaust camshafts for this DOHC
engine can be independently rotated with the
timing belts removed. As can be seen from the
figure, if the intake and exhaust valves are lifted
ME-00083
ME(H4DOSTC)-50
(4) Align single line mark (A) on exhaust cam-
shaft sprocket (LH) with notch (B) on belt cover
by turning the sprocket counterclockwise (as
viewed from front of engine).
(5) Align the single line mark (A) on intake cam-
shaft sprocket (LH) with notch (B) on belt cover
by turning the sprocket clockwise (as viewed
from front of engine).
Ensure the double lines (C) on intake and ex-
haust camshaft sprockets are aligned.
(6) Ensure the camshaft and crankshaft sprock-
ets are positioned properly.
( B )
( A )
ME-00084
( B )
( A )
( C )
ME-00085