Subaru Legacy 2003 Service Manual page 2253

AUTOMATIC TRANSMISSION
5) Install front sun gear and thrust needle bearing.
6) Install the high clutch hub.
Attach the thrust needle bearing to the hub with va-
seline and install the hub by correctly engaging the
splines of the front planetary carrier.
7) Install the thrust needle bearing in proper direc-
tion.
( B )
(A) High clutch hub
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
8) Install the high clutch assembly.
9) Install the thrust needle bearing in proper direc-
tion.
( A )
(A) High clutch and reverse clutch assembly
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
10) Install oil pump housing assembly with new
gasket.
11) Install torque converter clutch case. <Ref. to
AT-110, INSTALLATION, Torque Converter Clutch
Case.>
12) Insert inhibitor switch and transmission con-
nector into stay.
13) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
14) Install oil cooler pipes. <Ref. to AT-80, INSTAL-
LATION, ATF Cooler Pipe and Hose.>
PLANETARY GEAR AND LOW CLUTCH
( C )
( E )
( D )
( A )
AT-00234
( C )
( B )
( E )
( D )
AT-00258
15) Install the oil charger pipe with O-ring. <Ref. to
AT-84, INSTALLATION, Oil Charger Pipe.>
16) Insert the input shaft while turning lightly by
hand.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
17) Install the torque converter clutch assembly.
<Ref. to AT-85, INSTALLATION, Torque Converter
Clutch Assembly.>
18) Install the transmission assembly to the vehi-
cle. <Ref. to AT-42, INSTALLATION, Automatic
Transmission Assembly.>
AT-138
A
AT-00291