Subaru Legacy 2003 Service Manual page 2167

AUTOMATIC TRANSMISSION
D: INSTALLATION
1) Connect the inhibitor switch harness connector
to inhibitor switch.
2) Install the inhibitor switch to transmission case.
( A )
(A) Inhibitor switch
3) Move the range select lever to neutral position.
4) Place the inhibitor switch on specified position,
and then tighten the bolts for inhibitor switch using
ST.
ST 499267300 STOPPER PIN
Tightening torque:
3.4 N·m (0.35 kgf-m, 2.5 ft-lb)
ST
(A) Inhibitor switch
(B) Range select lever
5) Install the select cable to range select lever.
INHIBITOR SWITCH
AT-00038
( A )
( B )
AT-00039
6) Install the plate assembly to transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
T
(A) Select cable
(B) Plate ASSY
7) Install the washer and snap pin to range select
lever.
( C ) ( D )
(A) Range select lever
(B) Snap ring
(C) Select cable
(D) Washer
8) Install the front and center exhaust pipes. (Non-
TURBO model)
2.0 L and 2.5 L with OBD models
<Ref. to EX(H4SO)-6, INSTALLATION, Front Ex-
haust Pipe.>
2.0 L and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-10, INSTALLATION,
Front Exhaust Pipe.>
3.0 L model
<Ref. to EX(H6DO)-6, INSTALLATION, Front Ex-
haust Pipe.>
9) Install center exhaust pipe. (TURBO model)
<Ref. to EX(H4DOSTC)-8, INSTALLATION, Cen-
ter Exhaust Pipe.>
10) Lower the vehicle.
11) Install the inhibitor switch connector to stay.
AT-52
( A )
( B )
AT-00040
( A )
( B )
AT-00034