Subaru Legacy 2003 Service Manual page 2518

2) Install 3rd drive gear, baulk ring, sleeve and hub
assembly for 3rd-4th needle bearing on transmis-
sion main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
3) Install 4th needle bearing race onto transmission
main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
( A )
ST1
(A) 4th needle bearing race
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Face thrust washer in the correct direction.
( B )
(A) Groove
(B) 4th gear side
MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
MT-00192
( A )
MT-00193
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
ST1 899714110
ST2 499877000
6) Using ST1 and ST2, install the 5th gear thrust
washer and 5th needle bearing race onto the rear
section of transmission main shaft.
NOTE:
Face thrust washer in the correct direction.
ST1 899714110
ST2 499877000
(A) Face this surface to 5th gear side.
7) Install bearing onto synchro cone.
MT-77
REMOVER
RACE 4-5 INSTALLER
ST2
ST1
MT-00194
REMOVER
RACE 4-5 INSTALLER
( A )
MT-00195