Subaru Legacy 2003 Service Manual page 2170

17) Remove the transmission rear crossmember
bolts.
18) Lower the AT jack.
NOTE:
Do not separate the AT jack and transmission.
19) Remove the oil cooler inlet and outlet pipe.
NOTE:
When removing the outlet pipe, be careful not to
lose balls and springs used with retaining screws.
20) Remove the front torque converter turbine
speed sensor.
( B )
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
21) Remove the rear vehicle speed sensor.
( B )
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
22) Remove the oil pan.
FRONT VEHICLE SPEED SENSOR
AT-00043
( A )
AT-00044
( A )
AT-00045
AT-55
23) Disconnect each solenoid connector and re-
move ATF temperature sensor from control valve.
( B )
( C )
( A )
( J )
( G )
(A) Lock-up duty solenoid (Blue)
(B) Transmission ground
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Low clutch timing solenoid (Gray)
(K) Sport shift solenoid (Beige) (if equipped)
24) Remove the harness assembly.
AUTOMATIC TRANSMISSION
( D )
( E )
( K )
( I )
( H )
( F )
AT-00695