Subaru Legacy 2003 Service Manual page 2512

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
2) Install 3rd drive gear, outer baulk ring, synchro
cone, inner baulk ring, sleeve and hub assembly for
3rd needle bearing on transmission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
( A ) ( D ) ( E )
( B ) ( C )
(A) 3rd needle bearing
(B) 3rd drive gear
(C) Inner baulk ring
(D) Synchro cone
(E) Outer baulk ring
(F) Sleeve and hub ASSY
3) Install 4th needle bearing race onto transmission
main shaft using ST1, ST2 and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
( A )
ST1
(A) 4th needle bearing race
( F )
MT-00200
MT-00192
MT-71
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Align baulk ring and gear & hub assembly with key
groove.
( B )
(A) Groove
(B) 4th gear side
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
( A )
MT-00193
ST2
ST1
MT-00194