Subaru Legacy 2003 Service Manual page 2225

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Check the appearance of each component and
clean.
2) Force-fit the oil seal to the torque converter
clutch case with ST.
ST 398437700 DRIFT
3) Install the differential assembly to the case.
<Ref. to AT-124, INSTALLATION, Front Differen-
tial.>
4) Install the left and right side retainers. <Ref. to
AT-128, ADJUSTMENT, Front Differential.>
5) Install the new seal pipe to the torque converter
clutch case.
(A) Seal pipe
6) Install the rubber seal to the torque converter
clutch case.
(A) Rubber seal
7) Apply proper amount of liquid gasket to the en-
tire torque converter clutch case mating surface.
TORQUE CONVERTER CLUTCH CASE
ST
AT-00177
( A )
AT-00176
( A )
AT-00178
AT-110
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
( A )
(A) THREE BOND 1215
(B) Rubber seal
8) Install the torque converter clutch case assem-
bly without damaging bush and oil seal and secure
with six bolts and four nuts.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
9) Install the pitching stopper bracket and transmis-
sion ground cable.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
10) Insert inhibitor switch and transmission con-
nector into stay.
11) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
12) Install the oil cooler pipes. <Ref. to AT-80, IN-
STALLATION, ATF Cooler Pipe and Hose.>
( B )
AT-00179
AT-00175
AT-00173