Subaru Legacy 2003 Service Manual page 2256

D: ASSEMBLY
1) Install D-ring to low clutch piston.
2) Fit the low clutch piston to the low clutch drum.
(A) Low clutch piston
(B) Low clutch drum
3) Install spring retainer to low clutch piston.
(A) Spring retainer
(B) Low clutch drum
4) Install ST to low clutch drum.
ST 498437100 LOW CLUTCH PISTON
GUIDE
5) Set the cover on the piston with a press using
ST1 and ST2, and attach the snap ring. At this time,
be careful not to fold cover seal during installation.
ST1 498627100 SEAT
ST2 398673600 COMPRESSOR
PLANETARY GEAR AND LOW CLUTCH
( A )
( B )
AT-00269
( A )
( B )
AT-00270
ST
AT-00271
ST3 498437100
6) Install the dish plate, driven plates, drive plates,
and retaining plate, and secure with the snap ring.
( A )
(A) Snap ring
(B) Low clutch drum
(C) Dish plate
(D) Low clutch piston side
7) Check the low clutch for operation.
(1) Remove one-way clutch. <Ref. to AT-150,
REMOVAL, One-way Clutch.>
(2) Set the one-way clutch inner race, and apply
compressed air for checking.
(A) Apply compressed air
(B) Low clutch drum
8) Checking low clutch clearance. <Ref. to AT-144,
INSPECTION, Planetary Gear and Low Clutch.>
AT-141
AUTOMATIC TRANSMISSION
LOW CLUTCH PISTON
GUIDE
( C )
( D )
( B )
( A )
ST2
ST3
ST1
AT-00272
AT-00273
( B )
AT-00274