Subaru Legacy 2003 Service Manual page 2110

5. MT Drive Select Lever
A: REMOVAL
1) Set drive select lever to HI position.
2) Remove the knob.
(A) Drive select lever knob
3) Remove console box. <Ref. to EI-34, REMOV-
AL, Console Box.>
4) Remove the bolt installing drive select lever as-
sembly on body.
5) Remove flange nut, clip and then disconnect the
cable from lever assembly.
( A )
( C )
(A) Flange nut
(B) Lever ASSY
(C) Clip
MT DRIVE SELECT LEVER
( A )
CS-00190
CS-00102
( B )
CS-00067
B: INSTALLATION
1) Attach the drive select cable to the lever assem-
bly and secure with the clamp.
( A )
( C )
(A) Flange nut
(B) Lever ASSY
(C) Clip
2) Install drive select lever.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
3) Set drive select lever to HI position.
( A )
(A) HI position
4) Be sure to insert cable eye end bolt into lever
arm slit.
(A) Cable eye end bolt
(B) Lever arm
CS-21
CONTROL SYSTEMS
( B )
CS-00067
CS-00068
( A ) ( B )
CS-00069