Subaru Legacy 2003 Service Manual page 2501

MANUAL TRANSMISSION AND DIFFERENTIAL
2. DUAL-RANGE
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-32, REMOVAL, Manual
Transmission Assembly.>
2) Remove clutch release lever. <Ref. to CL-22,
REMOVAL, Release Bearing and Lever.>
3) Remove transfer case with extension case as-
sembly. <Ref. to MT-47, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove the input shaft holder.
( A )
(A) Input shaft holder
(B) Input shaft
5) Remove the high-low switch. <Ref. to MT-42,
REMOVAL, Switches and Harness.>
6) Using ST, drive out straight pin, and remove
high-low shifter lever.
ST 398791700 STRAIGHT PIN REMOVER 2
NOTE:
When driving out straight pin, remove it in the direc-
tion that it does not butt against transmission case.
( B )
(A) Straight pin
(B) High-low shifter lever
TRANSMISSION CASE
( B )
MT-00163
( A )
ST
MT-00164
7) Remove main shaft rear plate.
( A )
(A) Main shaft rear plate
8) Put vinyl tape around splines of right and left
axle drive shafts to prevent damage to oil seals.
(A) Vinyl tape
9) Separate transmission case into right and left
cases by loosening seventeen coupling bolts and
nuts.
MT-60
MT-00159
( A )
MT-00362
MT-00160