Subaru Legacy 2003 Service Manual page 2202

• VTD model
(A) Rear vehicle speed sensor
6) Install the transmission assembly. <Ref. to AT-
42, INSTALLATION, Automatic Transmission As-
sembly.>
EXTENSION CASE
( A )
AT-00710
AT-87
C: DISASSEMBLY
1. MPT MODEL
1) Take out the transfer clutch by lightly tapping the
end of the rear drive shaft.
NOTE:
Be careful not to damage the oil seal in the exten-
sion.
( B )
(A) Extension case
(B) Transfer clutch
2) Remove the transmission clutch pipe without
bending pipe.
(A) Extension case
(B) Transfer clutch pipe
2. VTD MODEL
1) Remove snap ring using ST1, ST2, ST3 and a
press.
ST1 398673600 COMPRESSOR
ST2 498627100 SHEAT
AUTOMATIC TRANSMISSION
( A )
AT-00119
( A )
( B )
AT-00120