Subaru Legacy 2003 Service Manual page 2480

4. Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect battery ground cable.
2) Remove the air cleaner case. (Non-TURBO
model)
<Ref. to IN(H4SO)-6, REMOVAL, Air Cleaner
Case.>
3) Remove the intercoooler. (TURBO model)
<Ref. to IN(H4DOSTC)-13, REMOVAL, Intercool-
er.>
4) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect battery ground cable.
2) Jack-up vehicle and support it with sturdy racks.
3) Remove the front, center, rear exhaust pipes
and muffler. (Non-TURBO model)
Without OBD
<Ref. to EX(H4SOw/oOBD)-9, REMOVAL, Front
Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-13,
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(H4SOw/oOBD)-14, REMOVAL, Muffler.>
With OBD
<Ref. to EX(H4SO)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-9, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-10, RE-
MOVAL, Muffler.>
4) Remove center, rear exhaust pipe and muffler.
(TURBO model)
<Ref. to EX(H4DOSTC)-7, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOSTC)-12, RE-
MOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOSTC)-13, REMOVAL, Muffler.>
TRANSMISSION MOUNTING SYSTEM
MT-00354
MT-39
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Remove the heat shield cover. (If equipped)
6) Set the transmission jack under the transmission
body.
CAUTION:
Always support transmission case with a trans-
mission jack.
7) Remove the rear crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
2) Install the air cleaner case. (Non-TURBO model)
<Ref. to IN(H4SO)-6, INSTALLATION, Air Cleaner
Case.>
3) Install the intercooler. (TURBO model) <Ref. to
IN(H4DOSTC)-14, INSTALLATION, Intercooler.>
MT-00355
MT-00079
T1
MT-00358